Silicon-based solar cells, by far the most prevalent type of solar cell available today, might provide clean, green energy but they are bulky, rigid and expensive to produce. Organic (carbon-based) semiconductors are seen as a promising way to enable flexible, lightweight solar cells that would also be much cheaper to produce as they could be “printed” in large plastic sheets at room temperature. New research from physicists at Rutgers University has strengthened hopes that solar cells based on organic semiconductors may one day overtake silicon solar cells in cost and performance, thereby increasing the practicality of solar-generated electricity as an alternative energy source to fossil fuels.
Vitaly Podzorov, assistant professor of Physics at Rutgers, and his colleagues observed that excitons – particles that form when semiconducting materials absorb photons, or light particles – can travel a thousand times farther in an extremely pure crystal organic semiconductor called rubene than the typically observed 20 nanometers previously observed in other organic semiconductors.
“This is the first time we observed excitons migrating a few microns,” said Podzorov, noting that they measured diffusion lengths from two to eight microns, or millionths of a meter. This is similar to exciton diffusion in inorganic solar cell materials such as silicon and gallium arsenide.
Once the exciton diffusion distance becomes comparable to the light absorption length, you can collect most of the sunlight for energy conversion,” he said.
Excitons are particle-like entities consisting of an electron and an electron hole (a positive charge attributed to the absence of an electron). They can generate a photo-voltage when they hit a semiconductor boundary or junction, and the electrons move to one side and the holes move to the other side of the junction. If excitons diffuse only tens of nanometers, only those closest to the junctions or boundaries generate photo-voltage. This accounts for the low electrical conversion efficiencies in today’s organic solar cells.
“Now we lose 99 percent of the sunlight,” Podzorov noted.
The scientists discovered that excitons in their rubrene crystals behaved more like the excitons observed in inorganic crystals – a delocalized form known as Wannier-Mott, or WM, excitons. Scientists previously believed that only the more localized form of excitons, called Frenkel excitons, were present in organic semiconductors. WM excitons move more rapidly through crystal lattices, resulting in better opto-electronic properties.
The team’s research also produced a new methodology of measuring excitons based on optical spectroscopy. Since excitons are not charged, they are hard to measure using conventional methods. The researchers developed a technique called polarization resolved photocurrent spectroscopy, which dissociates excitons at the crystal’s surface and reveals a large photocurrent. The technique should be applicable to other materials, Podzorov claims.
While the extremely pure rubrene crystals fabricated by the Rutgers physicists are suitable only for laboratory research at this time, the research shows that the exciton diffusion bottleneck is not an intrinsic limitation of organic semiconductors. The scientists say continuing development could result in more efficient and manufacturable materials.
“Organic semiconductors are promising for solar cells and other uses, such as video displays, because they can be fabricated in large plastic sheets,” said Podzorov. “But their limited photo-voltaic conversion efficiency has held them back. We expect our discovery to stimulate further development and progress.”
The Rutgers research team’s discovery is slated for publication in an upcoming issue of Nature Materials.
